Cisco cleared an issue in multiple products affected by a vulnerability in the Ethernet Frame Decoder of the Snort detection engine that could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition.

The vulnerability, labeled a high priority, is due to improper handling of error conditions when processing Ethernet frames. An attacker could exploit this vulnerability by sending malicious Ethernet frames through an affected device. A successful exploit could allow the attacker to exhaust disk space on the affected device, which could result in administrators being unable to log in to the device or the device being unable to boot up correctly.

Manual intervention is required to recover from this situation. Users should contact the Technical Assistance Center (TAC) to help recover a device in this condition.

Cisco released software updates that address this vulnerability, according to its advisory. There are no workarounds that address this vulnerability.

This vulnerability affects all open source Snort project releases earlier than Release 2.9.17. Click here for more information on open source Snort.

Schneider Bold

This vulnerability affects the following products, if they are running a vulnerable release of Cisco UTD Snort IPS Engine Software for IOS XE or Cisco UTD Engine for IOS XE SD-WAN Software and are configured to pass Ethernet frames to the Snort detection engine:

  • 1000 Series Integrated Services Routers (ISRs)
  • 4000 Series Integrated Services Routers (ISRs)
  • Catalyst 8000V Edge Software
  • Catalyst 8200 Series Edge Platforms
  • Catalyst 8300 Series Edge Platforms
  • Cloud Services Router 1000V Series
  • Integrated Services Virtual Router (ISRv)

Meanwhile, Cisco also fixed a vulnerability labeled medium in the web-based management interface of its AsyncOS Software for Cisco Email Security Appliance (ESA) and Cisco Content Security Management Appliance (SMA) that could allow an authenticated, remote attacker to access sensitive information on an affected device.

The vulnerability exists because confidential information included in HTTP requests exchanged between the user and the device. An attacker could exploit this vulnerability by looking at the raw HTTP requests sent to the interface. A successful exploit could allow the attacker to obtain some of the passwords configured throughout the interface.

Cisco released software updates that address this vulnerability, according to its advisory. There are no workarounds that address this vulnerability.

This vulnerability affected the following Cisco products and Cisco AsyncOS Software releases:

  • ESA – 13.5.1 and earlier
  • SMA – earlier than 13.8.0

Click here for additional information on other Cisco security advisories.

Pin It on Pinterest

Share This