There is no doubt the increase in terror attacks are a matter of concern worldwide. Most of these attacks involve the use of explosives.

Nitroaromatic compounds, such as picric acid (PA), 2,4,6-trinitrotoluene, and 2,4-dintirotoluene, are the most commonly used chemicals to make explosives. These chemicals, even in trace amounts, are also highly toxic to humans, animals, and the environment. As such, their fast and accurate detection can be effective in preventing explosions and environmental contamination.

The problem is most existing techniques to detect nitroaromatic compounds cannot be used in practical situations. For example, costly laboratory equipment, like gas chromatography or X-ray imaging, cannot be deployed in the field. Hence, lately, portable and cost-effective fluorescence based chemical detectors have gained popularity.

Fluorescence-based detectors operate on a phenomenon called aggregation-induced emission (AIE), which indicates the constituent polymers emit strong fluorescence at high concentrations, under aggregated condition. This fluorescence shows quenching (reduction in intensity) behavior in contact with nitroaromatic compounds. Chemicals often used to formulate AIE polymers are tetraphenylethylene (TPE), thriphenylamine (TPA), and distyrylanthracene derivatives. Conventional methods available for the formulation of AIE polymers are highly complicated, involving multi-step purification processes, proving detrimental in the application of AIE polymer-based probes. Therefore, simplification of their chemical synthesis is the need of the hour.

All that being said, researchers from Pusan National University, South Korea, led by Prof. Il Kim, developed a single-step synthesis procedure for an AIE active polymer — TPE conjugated-hyperbranched polyglycidol (HPG).

Schneider Bold

“We synthesized AIE active nanoparticles using commercially available HPG, that too in a simple single-step process,” Kim said. “This new protocol will eliminate earlier difficulties faced in the synthesis of AIE active nanoparticles and promote their use in the detection of nitroaromatic compounds.”

The novel single step protocol produces a TPE-HPG polymer solution that adds into water for formation of bright blue fluorescent TPE-HPG aggregated nanoparticles. Through empirical analysis, the researchers observed the strong blue fluorescence of these nanoparticles is quenched by almost 95 percent on addition of 90 µM concentration of PA. The minimum concentration of PA that can be detected using TPE-HPG nanoparticles is 40 parts per billion.

Aggregation-induced emission-active sensors show quenching of fluorescence emission on contact with nitroaromatic compounds.
Source: Pusan National University


As solid-state sensors are more convenient for on-field applications than nanoparticle solutions, the team immobilized the TPE-HPG nanoparticles on strips of paper by following a simple dip and dry process. The strips of paper were dipped in nanoparticle solution for 10 minutes followed by drying under vacuum at 50 degrees C for 24 hours. The paper-based sensors prepared this way emitted bright blue fluorescence under UV light, which was progressively quenched on addition of higher concentrations of PA.

“We demonstrated a facile synthesis protocol for a fluorescent nanoparticle that can be deployed as a solid-state sensor for detecting explosives,” Kim said. “The full potential of this technology is as yet untapped; it can be further customized for applications in chemosensing, bioimaging, and optoelectronics.”

Overall, by enabling fast, accurate, and in situ detection of explosives, the findings of this study could offer a significant technical support to security on a global basis.

Pin It on Pinterest

Share This