In one incident this past summer on July 9, a pollution incident occurred during well workover operations. A Bureau of Safety Environmental Enforcement (BSEE) investigation found 57 barrels of synthetic oil base for drilling fluids spilled into the Gulf of Mexico (GOM) during riser displacement.
The standpipe gate valve and bleed-off valve were left in the open position during the pump operation. The valves’ status was considered to be normally closed by personnel and assumed to be in the closed position. Workers did not physically check these valves during line-up verification prior to startup.
In another event on November 16, a pollution incident occurred during fluid transfer operations.
After abandonment operations, personnel cleaned the mud pits and left the reserve pit, desander, desilter, and degasser valves in the open position. After tour change, and without checking valve status, the crew started to transfer Synthetic Based Mud (SBM) from an offshore Supply Vessel to the mud pits.
In the transfer process, 458 barrels of SBM inadvertently discharged into the Gulf of Mexico due to the open valves. This incident is currently under investigation, but preliminary information shows operations procedures were not followed.
In the wake of the incidents, the BSEE recommends operators and contractors:
- Ensure the flow path of the fluid transfer systems are thoroughly understood by personnel when conducting pipe/valve verification
- Physically label fluid transfer system valves to help identify if they are in the correct position prior to startup
- Ensure the proper procedures are followed, while including duties and responsibilities of the personnel involved
- Follow Lock Out/Tag Out (LOTO) policy to establish physical barriers for overboard specific mud system components
- Review Safety Alert 224 and Safety Alert 292 that also discussed similar incidents

