Working on an offshore platform is dangerous work, there is no doubt, but sometimes even the most mundane of tasks can lead to an injury.

Take closing a ball valve, said officials at the Bureaus of Safety and Environmental Enforcement (BSEE) in a report.

In one case, an operator needed to close a ball valve when testing the Level Safety High (LSH) on the deck drain sump. As the operator gripped the valve handle with his right hand, the edge of a metal tag became lodged between the back of his hand and the bridle. As he forced the valve handle down and toward the vessel, the tag cut the back of his hand. The injured person was not wearing protective gloves at the time of the incident.

In another case, an operator was loosening a connector on a transmitter with channel lock pliers, his right ring finger contacted the sharp end of a metal band used to secure metal tags in place on piping.

That contact resulted in a laceration that required several sutures. Although he was wearing protective gloves at the time, they were not sufficient to prevent the injury.

Schneider Bold
  • So for future safety endeavors, BSEE recommended operators and contractors consider the following:
  • Ensure that offshore personnel always wear appropriate hand protection and other appropriate PPE for the job task being performed. It is recommended hand protection is always worn in work areas.
  • Maintain supplies of spare PPE at your facilities. Inspect all PPE and replace inadequate PPE before starting work.
  • Regularly verify all valve handles can function properly and without any obstruction that may cause injury.
  • Continuously look for sharp edges or protrusions during regular hazard hunts. File down or cover sharp edges when possible or mark them to increase their visibility.
  • Ensure all JSAs identify the risks involved with hand placement/safety and specify the PPE required for the job. Consider metal obstructions or nameplates as a line item on JSAs.
  • Include hand protection as a topic in the scheduled Health Safety and Environment (HSE) discussions and share lessons learned.

Metal band outlined near the TMC connector that caused laceration to an operator who was loosening a connector on a transmitter with channel lock pliers, his right ring finger contacted the sharp end of a metal band used to secure metal tags in place on piping.Source: BSEE

Pin It on Pinterest

Share This