Pinch points in any manufacturing environment can cause various forms of injuries from minor to major, but when you work on an offshore platform all forms of that particular injury are significant.

In the first half of this year, numerous incidents reported to Bureau of Safety and Environmental Enforcement (BSEE) ended up classified as pinch points.

Through ongoing investigations, it appears the tasks leading up to the incidents were primarily associated with lifting/rigging. Due to the significant increase in these types of occurrences in the Gulf of Mexico, BSEE concentrated on the relevant hazards to identify improvement opportunities.

Below are the descriptions of sampled events:

Incident 1: Rig floor personnel attempted to reposition a Connex box initially set in a precarious orientation on a pipe rack. When the crane operator began to lift the load, the box inadvertently shifted, causing the box to pin the arm of the individual monitoring the load between a sling rack and the load. The injured person sustained bruising and abrasions on his right arm.

Schneider Bold

Incident 2: During a dynamic lift offloading grating from the facility to the motor vessel (M/V), the M/V deckhand guided the load using a tagline. As the load approached the M/V, the crane operator lowered the boom to avoid an obstruction on the boat’s deck. Simultaneously, the deckhand began pushing the load with his hands to provide additional assistance in preventing contact. The load briefly contacted the boat deck during this movement, pinching the deckhand’s finger between the two pieces of grating being lifted, resulting in a partial amputation.

In an effort to keep operators safe, BSEE recommends workers to consider the following:

  • Verify all designated flaggers assigned to monitoring the load can maintain open communication and a clear line of sight throughout the lift
  • Ensure pre-job reviews contain discussion points for reducing the risk of a pinch point incident occurring, such as load dimensions, load travel path, environmental conditions (i.e., sea state and wind speed), and Stop Work Authority
  • Confirm the boom is centered over the load before the lift to minimize the potential for the load to swing
  • Validate an adequate amount of deck space is available to maneuver, control, and land the load safely
  • Emphasize to field crews hands-off/hands-free standards when a load is in suspension or transit
  • Promote the use of taglines throughout the entire lifting operation

Re-enactment of pinch point location as identified in Incident 1. In this incident, the worker sustained bruising and abrasions.
Source: BSEE

Pin It on Pinterest

Share This